Technical Forums» Casual Member Lounge» Noob question : half cut

Simmo
» CMF Member

Perth
Australia

Member since:
Piece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF Furniture

Posts:
New to forumNew to forumNew to forumNew to forumNew to forum

Noob question : half cut

 Tue 22 Sep 2015 10:59:33 PM
What's the best way of getting half cut k11 from jap?

Any site I can visit ? What's the cost of the import ?
mycra
» CMF Member

melbourne
Australia

Member since:
Piece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF Furniture

Posts:
Highly frequent posterHighly frequent posterHighly frequent posterHighly frequent posterHighly frequent poster

Re: Noob question : half cut

 Sat 26 Sep 2015 08:16:58 AM
whats the point in getting a JDM K11 halfcut...?
mycra
» CMF Member

melbourne
Australia

Member since:
Piece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF Furniture

Posts:
Highly frequent posterHighly frequent posterHighly frequent posterHighly frequent posterHighly frequent poster

Re: Noob question : half cut

 Sat 26 Sep 2015 08:19:22 AM
you can reco or get another locally in aus for less the the importer's commission fee....
Simmo
» CMF Member

Perth
Australia

Member since:
Piece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF Furniture

Posts:
New to forumNew to forumNew to forumNew to forumNew to forum

Re: Noob question : half cut

 Sat 26 Sep 2015 08:38:06 PM
unfortunately it's hard to get k11 halfcut in perth... ideally would like to get a performance upgrade done.