Technical Forums» Technical / Performance» INTAKE PIPING POSITIONING
|
Christopher » CMF Member brisbane Australia Member since:  Posts:  |
INTAKE PIPING POSITIONING |
Sun 09 Mar 2014 05:45:24 PM |
|
Hey guys could i also get some pictures of some of your intake piping to see where you guys have mounted them etc etc?? Cheers
|
||
|
|
||
|
gee-aye-dee » CMF Member Australia Member since: Posts: |
Re: INTAKE PIPING POSITIONING |
Sun 09 Mar 2014 05:59:32 PM |
|
Just saw your threads. have you considered checking out micra.org.uk? lots more users on there so more chance of a variety of pics/opinions
|
||
|
Christopher » CMF Member brisbane Australia Member since: Posts: |
Re: INTAKE PIPING POSITIONING |
Sun 09 Mar 2014 06:19:29 PM |
|
No i haven't seen that before cheers mate will sus it out
|
||
|
BigJohn » CMF Member Sydney Australia Member since: Posts: |
Re: INTAKE PIPING POSITIONING |
Sun 09 Mar 2014 07:21:51 PM |
|
Hope my following pics help:
Start with something like these. I utilised the 45 degree joiner instead of this 90 degree join picture here. The Sikaflex is used to join the pipe into the airbox. |
||
|
BigJohn » CMF Member Sydney Australia Member since: Posts: |
Re: INTAKE PIPING POSITIONING |
Sun 09 Mar 2014 07:22:41 PM |
|
Pic of the inlet into the airbox
|
||
|
BigJohn » CMF Member Sydney Australia Member since: Posts: |
Re: INTAKE PIPING POSITIONING |
Sun 09 Mar 2014 07:23:06 PM |
|
Another angle of the inlet into the airbox.
Here, I have used a soldering iron to enlarge the hole to fit the 65mm piping. |
||
|
BigJohn » CMF Member Sydney Australia Member since: Posts: |
Re: INTAKE PIPING POSITIONING |
Sun 09 Mar 2014 07:23:32 PM |
|
Another angle
|
||
|
BigJohn » CMF Member Sydney Australia Member since: Posts: |
Re: INTAKE PIPING POSITIONING |
Sun 09 Mar 2014 07:24:02 PM |
|
Piping flared inside the airbox
|
||
|
BigJohn » CMF Member Sydney Australia Member since: Posts: |
Re: INTAKE PIPING POSITIONING |
Sun 09 Mar 2014 07:24:56 PM |
|
Looking from the top down.
Here, I have used the heat gun and melted the pipe in slightly so as to not push on the clutch cable. |
||
|
BigJohn » CMF Member Sydney Australia Member since: Posts: |
Re: INTAKE PIPING POSITIONING |
Sun 09 Mar 2014 07:25:27 PM |
|
The underside / intake
|
||