Technical Forums» Aesthetics» Gauge installation
|
Santos » CMF Member Hungary Member since:  Posts:  |
Gauge installation |
Sun 04 Dec 2005 09:07:01 PM |
|
Hi!
I want to install an oil pressure and an oil temp. gauge in my Micra. Can you help me... Do I have to place some "extra" sensors or they can get the correct info from the factory ones (if it has a factory oil temp sensor?).. And if I have to get these sensors, where to put them? Thanks in advance |
||
|
|
||
|
antish_r » CMF Member melbourne Australia Member since: Posts: |
Re: Gauge installation |
Mon 05 Dec 2005 03:09:04 AM |
|
actually if you get the sensors when u buy the gauges
anyway you the oil temp gauge goes to your oil pan under your cylinder block |
||
|
antish_r » CMF Member melbourne Australia Member since: Posts: |
Re: Gauge installation |
Mon 05 Dec 2005 03:17:30 AM |
|
antish_r » CMF Member melbourne Australia Member since: Posts: |
Re: Gauge installation |
Mon 05 Dec 2005 03:18:59 AM |
|
http://buildingsite.igentics.com/sites/BDD25053-844A-470C-BFAD-4CBFD91ABD31/images/20020802_oil_pressure_sensor_1.jpg
thats the oil press sender which you shoul have to place the gauge |
||
|
antish_r » CMF Member melbourne Australia Member since: Posts: |
Re: Gauge installation |
Mon 05 Dec 2005 03:23:39 AM |
|
The stock oil pressure sending unit should be plugged hole at the base of the oil filter. The sending unit is mounted at a right angle so that it clears the front sway bar. Three fittings were used to mount the sender
|
||
|
antish_r » CMF Member melbourne Australia Member since: Posts: |
Re: Gauge installation |
Mon 05 Dec 2005 03:24:24 AM |
|
thats the pic where it should be but this isnt a micra engine
|
||