After some help in Adelaide

Hey all, this is really only to Adelaide members.
Just seeing if someone out there would be able to help bore out the centre of my new wheels a little. The wheels have a thinner bore where the hub centre bit slots in and the wheel doesn't fit on snug :(

Wheel shops are quoting me $70.... per wheel!

I've tried with a dremel but this will take me years.

Any help would be great!!!

Other alternative, longer studs and some 10mm spacers.

try machine/engineering shops instead of wheel shops? I would assume a lathe operator would be happy to do them after hours for cash?

Are they alloy or steel? I've done a couple of sets of alloys with a dremel and they didn't take too long. I used the cut-off disks to get most of the meat off and the sandpaper ones to clean it up.

I dunno, there's one place I might have to visit. ill give them a shot tomorrow. Alloy as far as I know, e30 bmw bottlecap wheels.