Technical Forums» General news and info» help with washer pump for series 2 micra

david
» CMF Member

Perth
Australia

Member since:
Piece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF Furniture

Posts:
Occasional forum userOccasional forum userOccasional forum userOccasional forum userOccasional forum user

help with washer pump for series 2 micra

 Fri 07 Jan 2011 08:38:31 PM
Does anybody know where I can get a replacement windscreen washer pump for my 96 series 2 micra. It had 1 pump with two outlets as per the haynes manual.

Nissan and 'nice' only seem to know about the micras that had two pumps side by side (I assume this is one of the few differences between series one and series two.)

Does anybody know how the series 2 pump managed to control which pipe it pumped out? Did it spin in opposite directions to pump out the different pipes?

David
mycra
» CMF Member

melbourne
Australia

Member since:
Piece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF Furniture

Posts:
Highly frequent posterHighly frequent posterHighly frequent posterHighly frequent posterHighly frequent poster

Re: help with washer pump for series 2 micra

 Sat 08 Jan 2011 02:50:40 AM
I retro fitted mine with a pump off the shelf from repco.. Think
The brand was Haigh. You just gotta get the correct 'type'.
david
» CMF Member

Perth
Australia

Member since:
Piece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF FurniturePiece of CMF Furniture

Posts:
Occasional forum userOccasional forum userOccasional forum userOccasional forum userOccasional forum user

Re: help with washer pump for series 2 micra

 Thu 13 Jan 2011 04:57:35 PM
I have one of the series 1 pumps and may end up puting it in to squirt front and back at the same time. Would rather get one that can fit straight in rather than chopping wires etc.