Manifolds for the CG13.

Looking around and i see that there are no off the shelf manifolds for the micra and wanted to know what the various members who have turbo'd their car have done.

I was thinking that if you get a manifold and cut at the exhaust plate and welded onto the CG13 flange would be the easiest option but i don't know what car has spacing the same as the cg13, i have though of the starlet 4efte one may be the same but it may not so i wanted you're opinions.

sfx performance in the united states have one. have a visit to them although there are no pics and its a bit pricey in my opinion!

actually $260 isn't half bad in my eyes as they aren't available here. Now gonna defo reapir the micra lying around and then start with the turbo.

What turbo is good for street driving with good power and little lag? Going with rx7 topmount to reduce lag of maybe a 3sgte chargecooler.

You can also call up/email HKS Europe and ask them for a turbo manifold for the Nissan Cube. They use the same engine as the K11 :)

If you ask them for a Micra one they will just tell you one doesn't exist though!

don't they use a 1.4? or is just a taller block?

As far as I know they do use the CGA3, however the manifold still fits, it's been used by a few people on the Micra Sports Club on CG13s without a problem :)

They call the CGA3 a 1.4L